Wudhgslc Low Power timer breakout Module for 3-5V Systems with 20uA Sleep Plug-and-play that powers down between tasks; supports rails, idle, and adjustable on-time via pot.

Prices from
27.80

Sponsored links

COMPARE ALL WEBSHOPS (1)

Description

Amazon Usage is easy. First, set your desired delay by adjusting the on-board trim pot: nearly-all-the-way-to-the-left is "once per 100ms" and all-the-way-to-the-right is "once every 2 hours". Then, connect up to your 3-5V power supply and then your project's power-in to pin. Finally, select a signal pin from your project to the Done pin. In your project's code or design, just make sure that it sets the Done pin high once it is completed with its task. The TPL5110 Power Timer is a stand-alone breakout that turn any electronics into low-power electronics! It of turning your project on/off using a built in timer that can vary from once every 100ms up to once every two hours. Basically, the turn on periodically, adjustable by potentiometer or resistor, and turn on your project's power. It then wait until a signal is received from the project to tell the that it can safely turn off the power. If the does not receive a signal by the set time-out, it reset the device like a watchdog timer. While the TPL5110 is running (but the remainder of the project is de-powered) the current draw is about 20uA (according to our Monsoon Power Meter).

Compare webshops (1)

Sponsored links · Some shops pay us a fee

Sort by:

€ 27.80

Description (1)

Usage is easy. First, set your desired delay by adjusting the on-board trim pot: nearly-all-the-way-to-the-left is "once per 100ms" and all-the-way-to-the-right is "once every 2 hours". Then, connect up to your 3-5V power supply and then your project's power-in to pin. Finally, select a signal pin from your project to the Done pin. In your project's code or design, just make sure that it sets the Done pin high once it is completed with its task. The TPL5110 Power Timer is a stand-alone breakout that turn any electronics into low-power electronics! It of turning your project on/off using a built in timer that can vary from once every 100ms up to once every two hours. Basically, the turn on periodically, adjustable by potentiometer or resistor, and turn on your project's power. It then wait until a signal is received from the project to tell the that it can safely turn off the power. If the does not receive a signal by the set time-out, it reset the device like a watchdog timer. While the TPL5110 is running (but the remainder of the project is de-powered) the current draw is about 20uA (according to our Monsoon Power Meter).


Product specifications

Brand Wudhgslc
EAN
  • 6031682830931

Featured Choice
€ 27.80
To Shop