[Updated] AURSINC NanoVNA H Vector Network Analyzer 9 kHz 1.5 GHz Latest HW Version 3.7 MF HF VHF UHF Antenna for Measuring S Parameters, Voltage, Standing Wave Ratio, Phase

Upgraded NanoVNA-H HW3.7: The AURSINC NanoVNA-H Vector Network Analyzer is designed by HUGEN, is tiny and portable. With the latest 3.6 version, it has a measuring range of 9 kHz - 1.5 GHz and a 2.8 inch LCD touch screen (320 x 240) with built-in 650 mAh battery. An ABS housing has been added, which is protective and dustproof. Supports time domain analysis function (TDR) Upgraded Frequency Algorithm The upgraded frequency algorithm can use the odd harmonic extension of si5351 to support the measurement frequency up to 1.5GHz. SI5351 direct output (50kHz-300MHz) provides >70dB of dynamics. The extended 300-900MHz band delivers >60dB, the 900MHz - 1.5GHz band > 40dB dynamics Multiple TX/RX Functions The default firmware main function is used for measuring antenna performance. With TX/RX method, full S11 and S21 parameters can be measured. Manual transceiver port rewiring is required to measure S12/S22. The CH0 output level when used is +0 dBm for more precise reflection measurements PC Software Control: Designed with a convenient and easy control application on PC (NanoVNASaver), you can download Touchstone (SNP) files for radio design and simulation software. Newly designed circuit board, you can connect Nanovna to a mobile phone with a type C type C cable. Compatible with most Android phones and Windows PCs BATTERY POWERED This VNA is battery operated or USB powered. Built-in 650mAh battery, can work continuously for 2 hours. The product surface shows battery consumption, providing a clear understanding of the energy status. Built-in micro SD port, support maximum 32GB memory card (not included) Package list: 1x NanoVNA H Host (2.8" touchscreen), 1x USB Type-C data cable, 2x 30cm SMA male to male RG174 RF cable, 1x SMA simple calibration kit, 1x SMA female to female plug, 1x USB Type-C cable, 1x touch pick, 1x stylus pen. Note: Our Nanovna is only compatible with low speed and supports SD cards in SPI mode for the time being