Compare webshops (1)
Sponsored links · Some shops pay us a fee
Shops with other sizes
It can provide 2 x 2.8W channels to a 4-ohm impedance speaker and has an I2C control interface and AGC (Automatic Gain Control) system. If you don't want to use I2C to control it, it will default to 6dB gain startup and set AGC for most music playback. However, we do recommend using it with a microcontroller to configure it, as it is very powerful. The settings are not stored in the chip, so you need to adjust any gain and AGC amplification settings every time the amplifier is powered on. The microchip contains a Class D controller that can operate at 5VDC. As this amplifier is a Class D amplifier, its efficiency is extremely high (89% when driving an 8ohm speaker with 1.5 watts), making it very suitable for portable and battery powered projects. It has built-in thermal protection and overcurrent protection. The input of the amplifier is through a 1.0uF capacitor, so they are completely 'differential' - if you don't have differential output, just ground the R- and L -. The output is' bridged '- this means they are directly connected to the output without grounding. The output is about 300KHz square wave PWM, and then "averaged" by the speaker coil - high frequencies cannot be heard. All of the above means that you cannot connect the output to another amplifier, it should directly drive the speaker. SHOP WITH CONFIDENCE: To provide you with the highest quality service, If you have any question, please contact us.We will provide after-sales service until you are satisfied.