PD/QC Decoy Negotiation Need fixed voltages from USB-C chargers for your DIY projects? This module negotiates PD3.0/2.0 and QC3.0/2.0 to output 5V, 9V, 12V, 15V, or 20V at up to 5A (100W). Turns any PD/QC power brick into a programmable DC source. Your must support the target voltage, otherwise it falls back to the next lowest available . DIP Switch Voltage Selection No programming—set onboard DIP switch per the reference table on PCB back. No soldering required. Compact size (approx. 25.7x11mm) fits tight enclosures . Always verify output with a multimeter before connecting to your circuit (no voltage indicator) . 5A 100W High-Power Output Supports up to 5A (100W at 20V). Powers laptops, routers, LED strips, soldering irons, and Raspberry Pi projects. Built-in over-temperature and surge protection. Input voltage range 4V to 22V . Plug & Play - No soldering pre-soldered USB-C input port. Just plug into any PD/QC power bank or wall , set DIP switch via the reference table, and start powering your projects. 5A output requires an E-marked Type-C cable; otherwise limited to 3A. DIY power supply and tester turn any PD/QC power bank into a bench supply. Also confirms performance before connecting expensive equipment. Essential for makers, repair technicians, and electronics hobbyists .
All merchants
- Amazon
- Polo Club
- Trodo
- Bazta
- Pig and Hen
- A4H-TECH
- Lookfantastic
- Bright Beauty Vanity
- Direct Repair
- Mizuno
- Ebay
- GoGroopie
- Tyres.ie
- DiamondsByMe
- The Scent Vault
- Fishdeal
- Snowcountry
- FixPart
- Limepack
- Decathlon
- Plusshop
- Zalando
- KitchenAid
- Emma
- Spotlight Oral Care
- Pretty Little Thing
- Amazon Marketplace
- Zooplus
- Baker Ross
- Marks and Spencer